基于现场可更换组件结构的宽带波形产生设计
作者:
作者单位:

作者简介:

通讯作者:

基金项目:

伦理声明:



Design of wideband wave generation based on the LRM framework
Author:
Ethical statement:

Affiliation:

Funding:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    给出了一种基于现场可更换组件(LRM)结构的4通道宽带波形产生板卡设计。板卡上集成了一款高性能的现场可编程逻辑阵列(FPGA)以及4片高速数模转换器(DAC)芯片。DAC和FPGA之间为高速低电压差分信号(LVDS)接口,板卡输入输出接口选用标准二代LRM连接器。DAC采样率为4 Gsps,在2.4 GHz中频(IF)上瞬时带宽达到了1.2 GHz,信噪比(SNR)优于50 dB。该设计可广泛应用于电子战和宽带雷达系统中。

    Abstract:

    A design of 4-channel wide band wave generation based on the Line Replaceable Module (LRM) framework is presented. The card integrates a high performance FPGA and 4 Digital Analog Converter(DAC) chips. The DAC and FPGA connect each other by the Low Voltage Differential Signaling (LVDS) interface. The input and output interface of the board utilizes a 2nd generation LRM connector. The DAC sampling rate is 4 Gsps. The instantaneous bandwidth is up to 1.2 GHz at 2.4 GHz Intermediate Frequency(IF) output, and the Signal-to-Noise Ratio(SNR) is better than 50 dB. It can be applied to the radar EW and the wideband digital receiver.

    参考文献
    相似文献
    引证文献
引用本文

陈 勇,谭剑美.基于现场可更换组件结构的宽带波形产生设计[J].太赫兹科学与电子信息学报,2018,16(3):436~439

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
历史
  • 收稿日期:2017-10-01
  • 最后修改日期:2017-11-14
  • 录用日期:
  • 在线发布日期: 2018-07-03
  • 出版日期: